Products

Telephone line protection filter

GRANIT-8
GRANIT-8

Telephone line protection filter

Where to buy?

GRANIT-8 telephone line protection filter is used to protect voice data against leakage through the two-wire lines of open telephone, conference and dispatch communications by way of acoustoelectric conversion.

The filter is meant to let the voice frequency band signals through under the normal mode of phone line’s operation, and weaken the high-frequency signals that can be supplied to the line in the event of high-frequency intrusion.

The Product is a four-terminal device that consists of two U-shaped inductive-capacitive segments and one diode bridge. The circuit’s diode bridge represents the Product’s input and is used to decrease the transmission coefficient under low signal levels. The signals that can be generated on the output of IT devices as a result of acoustoelectric conversions are suppressed. The circuit’s filter serves as an output segment of the four-terminal device and represents a low-pass filter with the cutoff frequency of no more than 28 KHz.

Attenuation inserted by the device in the voice frequency band of 0.3-4 KHz at the input signal level of 0.1 V
at least 65 dB
Attenuation inserted by the device at the frequency of 10 KHz at the input signal level of 0.1 V
at least 60 dB
Attenuation inserted by the device in the frequency band of 0.15-10 KHz at the input signal level of 5V
no more than 3 dB
Attenuation inserted by the device at the frequency of 50 KHz at the input signal level of 5 V
at least 6 dB
Attenuation inserted by the device at the frequency of 100 KHz at the input signal level of 5 V
at least 10 dB
The product’s electric circuits sustain between the input contacts in the idle mode
at least 105 V
The product’s electric circuits sustain the maximum load current of
0,1 A
Mean time between failures
at least 5000 hr.
Dimensions (no antenna)
57x40x16 mm
Weight,(no antenna)
no more than 0,3